Under the graphics section, you will find a variety of
MD and tape designs as well as general images that could be used for
your covers. Below are some notes on inserting the covers.
|
|
After you've cut around the cover, fold the back (upside down part) and
the front along the lines of the middle edge title bar. Lightly glue
(use weak paper glue) the tops of the back and front covers. Make sure
you glue the front side where the co lour is. This is so the cover will
stick to the casing as opposed to folding inwards. This is important because
the minidisc, once inserted, can catch on the cover if it is not flat
on the casing.
|
The easiest cover to insert is the tape cover. Although there are two sorts
of tape cases, these covers can fit both. It's just a matter of folding
or trimming the end bit (on the left next to the edge title bar). They fit
most cases perfectly. As in the diagram, fold the left side over the
back (white side facing up initially). Then fold along all the lines on
the design and slide the cover into the case.
|
|
| For more information on manipulating graphics please visit
the forum. |
